How to Install Satellites E-book

You could find the free download of this ebook at the end of this extract of the Ebook

Connecting the Satellite Receiver

The easiest way to aim the satellite dish is to temporarily place the satellite receiver connected to a small television at the dish antenna mounting location. DO NOT ATTEMPT THIS IF IT IS RAINING OR THE GRASS IS WET. Using a satellite meterwill simplify any installation! Remove the satellite receiver and remote control from the packaging. Install the included batteries into the remote control. Connect a coaxial cable from the lnbf on the dish antenna to the IF INPUT port on the back of the satellite receiver. Finger tighten these connections. Never use a wrench to tighten the lnb connection as this will severely damage the unit and void the warranty! Connect a short coaxial cable from the TV OUT port on the back of the satellite receiver to the antenna input of the television then set the channel 3/4 selection switch on the back of the satellite receiver to an unused channel in your area (usually channel 3) and turn the television on and set it to the matching channel. Plug the electrical cord into the satellite receiver and then into a surge protected power strip. The receiver will automatically power. Press the Channel Up or Down Arrow button to choose 3ABN English (this is the strongest channel on the satellite which will help you find the signal faster)

Get your FREE download HERE